NOSHOK

08/05/2026

If your instruments aren't designed for CIP/SIP, your next cleaning cycle might be their last. General purpose pressure and level devices often survive aggressive cleaning cycles - until drift, failures, and tough audit questions follow.

NOSHOK's 20, 25, and 30 Series sanitary transmitters are built for CIP/SIP service: meeting the requirements for 3-A and ASME-BPE, with active temperature compensation that keeps readings stable through hot cleaning cycles. One dairy plant reported a 4-6% improvement in inventory accuracy after switching.

See our sanitary solutions: https://hubs.li/Q04s0NSb0

08/03/2026

We made it! NOSHOK is on-site at AGMSC 2026, happening now through August 6 at Robert Morris University in Moon Township, PA.

Come find us at table #1204 - our team is ready to answer questions, show off our instrumentation solutions, and talk shop about all things gas measurement.

Already at the show? Snap a pic with us and tag NOSHOK!

07/30/2026

Most data center teams obsess over chiller efficiency – but ignore the health of the instruments feeding the BMS.

Every efficiency initiative starts with the same question: “Can we safely raise setpoints or reduce flow?” But if your pressure, level, and temperature transmitters are drifting, poorly located, or overspec’d, the data behind that decision can’t be trusted.

We often find:
- Instruments installed where they’re easy to reach, not where they give the best signal
- Ranges 2–3× higher than the actual operating window, killing resolution
- Devices that were never designed for today’s liquid cooling chemistries or temperature swings

The result is conservative setpoints “just to be safe” – and capacity and energy savings left on the table.

When instrumentation design and verification are tightened up, operations teams gain the confidence to run closer to optimal temperatures without increasing risk. That’s where meaningful PUE improvements come from.

When was the last time your team reviewed where and how cooling instruments are installed, not just whether they pass a quick check?

https://hubs.li/Q04qnFLw0

07/29/2026

We're on the floor in Grand Rapids!

Brandon and Dave are walking the Advanced Manufacturing Expo in Grand Rapids, ready to talk shop about NOSHOK's measurement solutions.

If you're at the show and want to meet up, drop a comment or send us a message - we'll coordinate a time to connect.

07/28/2026

You can’t optimize what you can’t trust – especially at custody transfer and other critical measurement points.

Tiny errors in pressure and level measurement at custody transfer or key process points can translate into large financial discrepancies over time.

We see operations dealing with:
- Instruments that no longer match the current operating envelope
- Seal fill fluids or materials misaligned with new process conditions
- Inconsistent calibration and verification practices across sites

The result is a constant debate about which numbers to believe – and a lot of time spent reconciling data instead of running the asset.

Standardizing on instruments designed for your actual service, and aligning ranges and seals with those conditions, makes it much easier to defend your numbers with partners, auditors, and regulators.

If you had to pick one measurement point in your operation where absolute accuracy matters most, which would it be?

https://hubs.li/Q04qtsM50

07/27/2026

We're hitting the road! NOSHOK will be at AGMSC 2026, August 3-6 at Robert Morris University in Moon Township, PA.

Come find us at Booth #1204 - we'll have our team on hand to answer questions, show off our latest pressure and instrumentation solutions, and chat all things gas measurement.

Tag a colleague who's headed to the show, and we'll see you there!

07/23/2026

We're headed to Grand Rapids!

Brandon Guse and Dave Wytcherley from NOSHOK will be at the Advanced Manufacturing Expo on July 29, ready to talk pressure, level, and temperature measurement solutions for your plant.

If you'll be there too, let us know - we'd love to meet up, answer questions, and show you what NOSHOK can do for your operation.

See you in Grand Rapids! Comment or message us to connect.

07/22/2026

Check out NOSHOK’s Hazardous Location Classifications video – a high-level look at how fuel, oxygen and ignition sources define hazardous locations, and how proper area classification helps reduce risk in critical applications. See how NOSHOK Explosion-Proof, Non-Incendive and Intrinsically Safe transmitters are applied in oil & gas, chemical processing, offshore, mining, tank monitoring and more to support reliable measurement in hazardous environments.​​

Watch now and learn how NOSHOK can support your next hazardous location installation. https://hubs.li/Q04pSk8B0

Understanding Hazardous Location Classifications & Pressure Transmi...

07/21/2026

Selecting the right pressure transmitter can make a significant difference in refrigeration system performance and reliability.

Learn what to look for and how the NOSHOK PT30 is designed to handle demanding conditions while supporting long-term efficiency.

Read more: https://hubs.li/Q04p-VwD0

07/17/2026

Hope this clears things up! We measure a lot of things. World Cup pressure, heat waves, and lettuce parasites are not on that list. Stay safe out there.