Dominarc

11/15/2019

In case I forgot how humid south Mississippi is, I filled an above-ground pool to use the water for some testing of a project. The water in the pool was so much colder than the air that the water condensed out of the air onto the outside of the pool.

11/11/2019

Hey guys!! Did you know we’re also on Instagram?? Yes!! It’s true!! Follow us !

Or visit our website at:
https://dominarc.com

You can slay give us a call or direct message through Facebook! We love hearing from our clients and fans!

Justin can be reached at 346-205-5524, & Crystal at 228-243-5375.

WELCOME INVENTORS! REVIEW OUR SERVICES AND START YOUR PRODUCT DEVELOPMENT JOURNEY TODAY!

11/11/2019

Today we’re testing components to be used in a prototype. It’s an anchor that is driven by an impact hammer with a 1” bit! This bad boy makes a lot of noise but it got the job done!!

11/11/2019

We scored this brand new Dewalt air compressor for half price !!

11/06/2019

We took our four children camping this past weekend. The weather was wonderful and we had a great time!! It’s important to take time to smell the fresh air. @ Paul B. Johnson State Park

11/05/2019

We were asked to make repairs to a 1945 Harley Davidson gas tank. It had several areas of corrosion. We created panels to cover the largest areas to improve the integrity. It was leak checked with air to 25psi and now it’s ready to be restored!

11/05/2019

We were asked to make repairs to a 1945 Harley Davidson gas tank. It had a large area of severe corrosion on one end. We formed a new piece to cover the whole area and it was leak checked with air pressure to 25psi. Now it’s in excellent condition to be restored!

10/30/2019

Our skilled welder hard at work...

10/22/2019

Do you need a 3D digital drawing file or a 3D print? We can help with that! We can turn your 2D image, sketch or drawing file into a 3D digital model and get a 3D print for you! Get a free estimate now! Starting at $25 for small pieces.

In the example below is a custom camera tether. The diameter of the base is about 1.5". We created the model in SolidWorks and the actual sample was printed from nylon. The printing method used was FDM (Fused Deposition Modeling), which leaves visible layers, but is substantially less expensive than other methods for simple test samples. To model and print this sample was $25.