McCain Machining LLC

10/07/2023

Single axle dumb truck repair we did a few weeks back. Replaces the shaft in the cylinder, machined a new cylinder rod end, and installed new bushing in the bed lift. Give McCain Machining a call for all your cylinder repair, machining, and fabrication needs.

18/02/2023

This is a breakdown job we did first of this week. Bearings locked up and it all went downhill from there. We were able to get them back up and running in a couple days. Give us a call for reliable work and quick turnaround. Like and share this post for a chance at a McCain Machining hat and shirt.

02/02/2023

Roller repair we did last week. Turned out nice considering what we had to start with. Would like to thank A&M Grading for there continued business. Give us a call for all your machining/fabrication needs.

05/01/2023

04/01/2023

Hammer mill shaft we repaired a couple of weeks ago. Bearing went down on the shaft so we had to build the shaft back up, machine a new bearing fit, and turn new threads for the lock nut. Give us a call for all your machining/fabrication needs small or large.

19/10/2022

A few jobs we have finished up this week. Call us for all you machining, fabricating, and cylinder repair needs.

22/09/2022

Hydraulic Cylinder we repaired this week. Threads and nut were damaged in the past. Someone drove the nut on and welded it to the shaft which failed to hold. Built up and machined new threads, new nut, new seals and it is good as new. Give us a call for all your Machining needs.

13/09/2022

Some PHT 4140 shafts we finished up today.
Give us a call for all you machining needs.

19/01/2022

Skidder yoke repair we finished up today. Someone got a little excited with a torch before they brought it to us 😅. Made it a little interesting but turned out great.

30/11/2021

22” Diameter Flywheel resurface

31/07/2021

Big job we finished up today. These will be mounted on forklifts. The hubs have two 180mm bearings pressed inside them with the shafts pressed inside the bearings. The shaft is rated to pick up 6000lb and still be able to rotate.

27/05/2021

Big load of pre machined 14 dia. 1045, 3” dia. 4140, and some 4” dia. 1018. Will be keeping our lathes busy for a little while. Stay tuned for the finished product/assemblies.