Tinsley Equipment Company

02/03/2018

Add a Bag Palletizing Robot to your existing bagging operation. Minimum of 20ft x 20ft required to get started. Watch a video and learn more here:

The video below shows a robot that stacks filled 50 pound paper valve bags onto a wooden shipping pallet located on the floor per the programmed bag placement design. This robot was added to an existing bag filling system to reduce labor costs. Watch a Video: https://youtu.be/9WUEsX4DC6A

02/03/2018

Bagging flour or other types of powders? Check out this video of a machine that fills and seals valve bags at a rate of 3-4 bags per minute with good weight fill accuracy:

This flour bagging machine fills and seals valve bags at a rate of 3-4 bags per minute with good weight fill accuracy. Filling can be mostly dust free with this type of flour, but dust collection is still recommended. This is a proven design refined over many years to give users an accurate fill w

28/11/2017

The CBE 730 Air Packer is used for bagging mineral powders, mortar mixes and food products into valve bags with internal spouts.

24/11/2017

Three urethane screen panels per deck surface are designed for long life cycle with silica sand. Spray bars are used to repulp the sand to increase recovery efficiency. Vibratory drive motor is designed to vibrate a total of 5 screen decks. Recovered silica sand product is returned to plant for processing and drying. Learn more:

Wet frac sand tailings stream is being processed to recover product before wet sand tailings are sent back to quarry. Water and silica sand is processed over a urethane screen panel designed to remove any remaining product from the tailings stream. Three each urethane screen panels per deck

23/11/2017

Wet frac sand tailings stream is being processed to recover product before wet sand tailings are sent back to quarry. Water and silica sand is processed over a urethane screen panel designed to remove any remaining product from the tailings stream. Learn more: https://goo.gl/NyY5ZG

22/11/2017

This boiler ash handling and recovery system is designed to remove unburned carbon (char), ash, grit and sand from waste water discharged from wood and bark power boiler. Slurry, composed of water and solids, is sent from the wet precipitator to the Derrick HI-G® Dewatering Machine at rates from 800 to 2200 GPM. Learn more:

Boiler ash removed from water using dryer and screens. Unburned carbon is collected for re-burning. Ash, grit, sand is sent to land fill.

22/11/2017

Boiler ash handling and recovery system using a Derrick HI-G® Dewatering Machine. Learn more: https://goo.gl/pfnXL8

21/11/2017

High capacity wet screening and dewatering units offered for a wide range of sizing and classification tasks. Wet screening units are designed to efficiently screen out fines and classify oversize particles. Dewatering units have proven throughput of up to 300 TPH (tons per hour), and are designed to maximize solids recovery and minimize waste water. Learn more: www.TinsleyCompany.com