NoWeare Forge

  • Home
  • NoWeare Forge

NoWeare Forge Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from NoWeare Forge, Metal Fabricator, .

Another day in the forge and we are working on scrolling.Got 1 ribbon scroll done. Its a decent first attempt some refin...
10/05/2026

Another day in the forge and we are working on scrolling.

Got 1 ribbon scroll done. Its a decent first attempt some refinement is needed. Looking at it now there are tight spots a 3, 9 and 11.

Onward to more pratice.

10/05/2026
Another day in the forge and abounds. Punching various holes in various bars. Round in round looks decent but the other...
19/04/2026

Another day in the forge and abounds. Punching various holes in various bars. Round in round looks decent but the other two are a bit off center. More pratice to come.

Another day in the forge and stuff again. After like 5 attempts I have an acceptable turning wrench. All thst is left i...
20/03/2026

Another day in the forge and stuff again. After like 5 attempts I have an acceptable turning wrench. All thst is left is some filing to clean it up and some case hardening.

Also punched diamond holes in 1/2" square bar the holes look good but they are slightly out of line with the center of the bar. More pratice is needed but we will get there.

Another day in the forge and we continue stuff. Messed up another scrolling wrench, started another. Head/bench.Also di...
15/03/2026

Another day in the forge and we continue stuff. Messed up another scrolling wrench, started another. Head/bench.

Also did some pratice punching holes in 1/2" round the holes look good (the squished one was nice before the one on the other end was done) but the punch is pulling down material so more upset is needed there.

Another day in the forge and it's stuff again. Started a new scroll wrench. This one will have all the correct dimensio...
05/03/2026

Another day in the forge and it's stuff again. Started a new scroll wrench. This one will have all the correct dimensions and not be 1/16th to small again.

Punched a round hole in the round bar the hole looks good but the upset is crap but we are getting there. Also upset more bars for more punched holes.

Lastly refined the diamond drift as the current one was too thick on the end and left a less than desirable hole because I had to punch too far with the chisel to get it to fit.

Onward to more pratice.

Address


Website

Alerts

Be the first to know and let us send you an email when NoWeare Forge posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

  • Want your business to be the top-listed Engineering Company?

Share