Stigs performace and classics

Stigs performace and classics Mechanical repair business

Carter thermoquad and Rochester quadrajet both gone through and kitted and ready to go back on. Both stripped and ultras...
07/04/2026

Carter thermoquad and Rochester quadrajet both gone through and kitted and ready to go back on.

Both stripped and ultrasonic cleaned, all gasket faces sanded flat and reassembled with major rebuild kits. Quadrajet had extremely worn primary throttle shafts so was drilled and bronze bushings installed to bring back into spec

Suns out so outside stripping down a thermoquad for a bronco and quadrajet for a vh commodore. Ultrasonic clean, new reb...
28/03/2026

Suns out so outside stripping down a thermoquad for a bronco and quadrajet for a vh commodore. Ultrasonic clean, new rebuild kits and throttle shaft bushes for the quadrajet

Rail, hail or over priced fuel, Stigs still out and still going. Back in western Sydney end of March til early April onl...
13/03/2026

Rail, hail or over priced fuel, Stigs still out and still going. Back in western Sydney end of March til early April only for acouple weeks any work needed give us a call we’ll spots are available 0467 178 237

Emergency repair on a pretty wild old customline heading to tail draggers inventional in newcastle dead altenator luckil...
06/03/2026

Emergency repair on a pretty wild old customline heading to tail draggers inventional in newcastle dead altenator luckily head a new one on the shelf and back on the road with a new power master 140amp and alittle wiring

Enjoy the trip guys mad to hang out

Some more work done before- Astra power steering pump on a ve commodore plumbed and wired, due to being on e85 and new 1...
15/02/2026

Some more work done before

- Astra power steering pump on a ve commodore plumbed and wired, due to being on e85 and new 1/2 inch fuel lines being ran was able to utilise the original fuel hard lines to get under the car being really low, and run up through the driver rear rail into the boot where we have mounted the pump due to no space in front of vehicle.

- Trans service, new trans cooler and lines done on a ht Holden along with redoing the brake hardlines to the proportioning valve as we’re plumbed back the front and remove the residual pressure valve as this car has been fitted with 4 wheel disc brakes. No more trans leaks and stops a lot better now.

Couple jobs knocked through this week inbetween a heap of other work - diff overhaul on a 10.25 sterling in an f250 supe...
01/02/2026

Couple jobs knocked through this week inbetween a heap of other work

- diff overhaul on a 10.25 sterling in an f250 super duty along with rebuilding the l*d, all new brakes and hand brake parts

- 67 Camaro to fit billet bonnet and boot hinges along with billet accelerator pedal

- big turbo ve for twin trans coolers to keep the 4l80’s temps under control and ptfe cooler lines all tucked in tight to hide behind the big F off intercooler this combo needs. Also tiding up the wiring harness and fixing some loose ends on it

taking bookings for my next Sydney trip most likely around late March to April. As i have acouple big projects to button up in port Macquarie before i come down again.

Let Stig’s get that project sorted in 2026 !!!

0467 178 237 m ari

Nice way to start a week, up early on on a plane down to Adelaide and back on Monday to do a pre purchase with a long t...
20/01/2026

Nice way to start a week, up early on on a plane down to Adelaide and back on Monday to do a pre purchase with a long time customers first classic, tidy little ht kinga with a mild 308, acouple small things to tidy up but I think Cameron will enjoy this more then his previous plastic bumper Holdens, plus get more looks. Congrats mate welcome to the chrome bumper family.

Will see more of this one as we ad things like aircon. Electronic vac pump and acouple nice upgrades to make this a perfect tuff weekend cruiser as time goes on.

Abit late but Happy new year to everyone!!! Has Been a quick minute and have been slack on posts but will have some good...
10/01/2026

Abit late but Happy new year to everyone!!!

Has Been a quick minute and have been slack on posts but will have some good ones once one of the current long term jobs is further along. Quick run up north at Little to pick up the next resto for Stig’s. A 1968 semi auto beetle. after sitting for the better part of 14-15 years, time to bring new life into the old girl before it travels south to meet back up with her owner and see the road again.

Sadly I’ve had to promise the lovely owner that I won’t hotrod this one as I have been known to cut these vw’s up in the past 🤣🤣🤣 so this will be a return to showroom factory job. Will post bits and drabs as time goes on.

We’ll finally after working the guts out of the old girl the last year the work truck got a rebuild and no longer burnin...
18/05/2025

We’ll finally after working the guts out of the old girl the last year the work truck got a rebuild and no longer burning and leaking oil, bottom end rebuilt and all Gone through, new drp alloy heads, crow cam. the intake, carb and extractors swapped over from before. Running it in towing the trailer around doing work on the property up at port Macquarie but she’ll be back in Sydney soon on work duties.

Video in comments of how the big girl sounds

Done last time I was up a port and didn’t get around to posting it, misubishi triton in for some upgrades. - 2 inch lift...
18/05/2025

Done last time I was up a port and didn’t get around to posting it, misubishi triton in for some upgrades.
- 2 inch lift kit
- staino snorkel
- bull bar
- upgraded transcooler
- plazaman intercooler
- catch can
- relocate washer bottle and over flow bottle due to snorkel and bullbar
- long range full tank
- roof console and uhf
- revrese camera and dash cam

Coming back this week for some more maitenace work including timing belt and fixing some oil leaks found when doing the work previously but should be a cracker first car for our customer will.

Last big job before Stig’s moves north, was a great trip to Melbourne to help a good friend out and make some progress o...
10/04/2025

Last big job before Stig’s moves north, was a great trip to Melbourne to help a good friend out and make some progress on his beautiful 64 ranchero .

- plumb all new fuel hardlines and brake lines
- fit new wiring harness and repair parts of original harness that were reused
- refit engine and transmission with new clutch, flywheel, starter and engine mounts
- fit up all front accessories
- Reco power steering pump
- fit up cooling system and heater box
- set up clutch linkage and pedal box
- get vehicle to run off key and all electrical working
- fit Reco diff
- begin to fit up interior
- replace all fluids
- refit steering column
- fit origanal 4 speed tunnel to new floor
- go over and tighten/inspect suspensionension

Plus 100’s of other little fidly bits

Definitely more down the alley of what we specialise in and looking forward to working on more of the collection the future.

Address

Hawkesbury, NSW
2758

Opening Hours

Monday 8am - 5pm
Tuesday 8am - 5pm
Wednesday 8am - 5pm
Thursday 8am - 5pm
Friday 8am - 5pm
Saturday 8am - 5pm
Sunday 8am - 5pm

Telephone

+61467178237

Website

Alerts

Be the first to know and let us send you an email when Stigs performace and classics posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Stigs performace and classics:

Shortcuts

Share

Category