Woz Fab

Woz Fab Specialising in custom sheet metal, chassis fab, suspension design as well as vehicle restoration. Based in Kyabram, Victoria

The 37 Dodge is sealed up almost back together after the majority of the lower half of the car was replaced. Flick throu...
25/06/2026

The 37 Dodge is sealed up almost back together after the majority of the lower half of the car was replaced. Flick through to see how rusty this was.
The Hare & Forbes Machineryhouse sand blasting cabinet got a workout, cleaning up the parts in preparation for paint.

Matt sealed up the underside in KBS Coatings Australia rust seal and textured TXT liner from Car Builders, he also painted the underside of the boot and firewall in body colour.

It’s almost ready to go back to its owner where it will see final paint and assembly. It was great to be a part of bringing this 37 Dodge back to life.

metalfab

80 Series Landcruiser fan shroud we made to suit a 6bt engine conversion. The lower section of the shroud is removable t...
29/05/2026

80 Series Landcruiser fan shroud we made to suit a 6bt engine conversion. The lower section of the shroud is removable to allow ease of installation to the vehicle.


Craig's D22 Nav came in for some rework and to continue the build after previously being started elsewhere. It came to u...
23/05/2026

Craig's D22 Nav came in for some rework and to continue the build after previously being started elsewhere. It came to us unfinished and needing a few changes to improve the geometry, so the chassis has since been cut apart, rewelded and straightened.

The rear tube section above the fuel cell will also double as the fuel cell straps, so those sections will be made removable.

These battery trays hinge down under the tub of Glenn’s courier to make replacing the battery a straight forward exercis...
21/03/2026

These battery trays hinge down under the tub of Glenn’s courier to make replacing the battery a straight forward exercise.

Isuzu Dmax cab mount we modified to clear larger tyres. Internally fish plated and weld tested for Vass Engineering. ...
17/02/2026

Isuzu Dmax cab mount we modified to clear larger tyres. Internally fish plated and weld tested for Vass Engineering.

Made up some mounting structures for the side steps on the 37 dodge. These were loosely replicated from what was left of...
11/02/2026

Made up some mounting structures for the side steps on the 37 dodge. These were loosely replicated from what was left of the rusty original parts and then plug welded into place.

Fabricated some new side steps for the 37 dodge. Used what was left of the originals to make the paper pattern which was...
10/01/2026

Fabricated some new side steps for the 37 dodge. Used what was left of the originals to make the paper pattern which was used to transfer the information to a flat piece of sheet metal.
The steel was pre stretched on the swage lines using the little English wheel before beadrolling the panel.
The edges were then folded and tipped over using the beadroller and the corners were welded up.

The 37 dodge is off the rotisserie and back on its chassis to finish the rest of the rust repairs and check fitment. ...
04/01/2026

The 37 dodge is off the rotisserie and back on its chassis to finish the rest of the rust repairs and check fitment.

Address

Wilson Road
Kyabram, VIC
3620

Opening Hours

Monday 9am - 5pm
Tuesday 9am - 5pm
Wednesday 9am - 5pm
Thursday 9am - 5pm
Friday 9am - 5pm

Website

Alerts

Be the first to know and let us send you an email when Woz Fab posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Woz Fab:

Shortcuts

Share

Category