Rover71

02/05/2022

তাক্বাব্বালাল্লাহু মিন্না ওয়া মিনকুম!

পবিত্র মাহে রমজানের পর এলো খুশির ঈদ। ঈদের আনন্দ সবার মধ্যে সমানভাবে ছড়িয়ে পড়ুক। সবাই পরিবারের সাথে সুস্থভাবে ঈদ উদযাপন করুন।
সবাইকে ঈদের শুভেচ্ছা। ঈদ মোবারক❤️

যাদের ঈদের সালামি লাগবে কমেন্ট বক্সে নাম্বার দিয়ে দিন সবাইকে সালাম দেয়া হবে 😀

19/04/2022

Our team at International Conference Center.

19/04/2022

The HC-05 is a very cool module which can add two-way (full-duplex) wireless functionality to your projects. You can use this module to communicate between two microcontrollers like Arduino or communicate with any device with Bluetooth functionality like a Phone or Laptop. There are many android applications that are already available which makes this process a lot easier. The module communicates with the help of USART at 9600 baud rate hence it is easy to interface with any microcontroller that supports USART. We can also configure the default values of the module by using the command mode. So if you looking for a Wireless module that could transfer data from your computer or mobile phone to microcontroller or vice versa then this module might be the right choice for you. However do not expect this module to transfer multimedia like photos or songs; you might have to look into the CSR8645 module for that.

🔰HC-05 Technical Specifications:

✅Serial Bluetooth module for Arduino and other microcontrollers

✅Operating Voltage: 4V to 6V (Typically +5V)

✅Operating Current: 30mA

✅Range:

17/04/2022

The Arduino Uno R3 is an open-source microcontroller board based on the ATmega328 chip. This Board has 14 digital input/output pins, 6 analog input pins, an Onboard 16 MHz ceramic resonator, a Port for USB connection, an Onboard DC power jack, An ICSP header, and a microcontroller reset button. everything needed to support the microcontroller. External (non-USB) power can come either from an AC-to-DC adapter (wall-wart) or battery. The adapter can be connected by plugging a 2.1mm center-positive plug into the board's power jack. Also leads from a battery can be inserted in the Gnd and Vin pin headers of the Power connector. The board can operate on an external supply of 6 to 20 volts. If supplied with less than 7V, however, the 5V pin may supply less than five volts and the board may be unstable. the voltage regulator may overheat and damage the board. The recommended range is 5v to 12v for Arduino Uno.

🔰 Features :

Microcontroller: ATmega328P.
Operating Voltage: 5V.
Input Voltage: 7-12V.
Digital I/O Pins: 14 (of which 6 provide PWM output).
Analog Input Pins: 6.
DC Current: 40mA.
Flash Memory: 32 KB.
SRAM: 2 KB.
EEPROM: 1 KB.
Clock Speed: 16 MHz.

17/04/2022

15/04/2022

14/04/2022

🔰 Project Name : ROBUST

🔰 Feature : It's moving on any surface and It's rotate instant 360° own position

14/04/2022