2026-11-18
Elongation is the single direct measure of chain wear. Here is how to take it properly.
A chain does not stretch. Sliding friction between the pin and the bushing wears away steel, and the centre to centre distance between joints grows.
Lock out first. Then:
Pick a straight span of the carrying strand still held taut by the take-up and the strand weight. Never measure chain wrapped around a sprocket, or lying slack on a return track. Both read false.
Measure across 10 to 20 pitches, pin centre to pin centre, with a steel rule or steel tape. More pitches in the span means better accuracy. A single pitch sits inside the noise.
Compare the measured span against nominal pitch multiplied by the pitches you measured. The difference, as a percentage, is your elongation.
Then read it against the right limit, because there is no single one:
Large sprocket of 67 teeth or fewer - replace at 3%
Large sprocket of 68 teeth or more - replace at 200 divided by the tooth count
Fixed centres, or strands running in parallel - replace at 1.5%
Drag and elevator chain - replace at 3%
Monitor from half the limit. Past that point, order the replacement. At the limit, fit it.
The spread is geometry, not inconsistency. The bigger the sprocket, the further a worn roller climbs the tooth for the same percentage of wear, which is why the allowance falls as the tooth count rises.
One caveat worth knowing. Chain makers publish their own figures and several are more conservative than the general rule. Tsubaki puts transmission chain at 1.5% and conveyor chain at 2%. Where your chain maker gives a number, theirs governs.