10/13/2026
Phew! We finally found some time for a new post! 🔥
The prototype for a custom center console we designed for The Gear Shop Ford Bronco Raptor is finished and has already been put to the test in the dunes of Morocco! 🏜️🚙
The team modified their rig themselves, and they brought us in for a very specific challenge.
The main objective of this project was to engineer custom, integrated mounts for the race-issued navigation tablets without eating up precious cabin space. To make this work, we had to delete the factory right-side air vent.
However, good airflow is absolutely critical in a rally environment. 💨
To solve this, we designed a completely custom ducting system. We created a custom splitter and tubing hooked up to the original HVAC location, routing the air to two new vents: one top-center on the console, and another down by the glovebox.
This project definitely threw some curveballs at us. The OEM panels are extremely thin and prone to warping during 3D scanning. To capture the true geometry, we had to build custom jigs just to hold them in place. 3D printing these long, thin-walled components was no walk in the park either, but the final result speaks for itself! 🖨️📐
Overall, the project was a massive success, and we can’t wait to hear the post-race feedback from The Gear Shop on how their Bronco performed! 🏁
Let us know what you think of this custom setup in the comments! 👇