Maxis CNC

23/10/2026

Down to Bedfordshire today for the service and calibration of a GMM Brio CNC.

Machine is great condition for ten years old. Greasing system working well, rails and bearings showing very little signs of wear, no water or moisture in the motor terminal tunnel and only minor calibration adjustments required.

As always test cuts performed to ensure customer is happy with the accuracy achieved.

22/10/2026

21/10/2026

GMM Egil CNC now sold and moving to the Architectural masonry side of the industry.

This machine will transform the new customers production opportunities which will be great to see.

19/10/2026

Bristol today for the supply and fit of a new air conditioner on a GMM Brio.
The original unit was deemed not viable to repair due to cost so a new item was chosen.

Customer opted for installation as this new model requires some additional fabrication to the electrical cabinet door.

16/10/2026

Back down to Dorset today for the camera setup of a GMM Brio, clear image and accurate again 👌

15/10/2026

Working in Surrey today carrying out investigations as to why the camera on a GMM Brio CNC had stopped working.

We found after the usual checks that the network configuration was wrong and the machine could not see the camera,in addition to this the camera cable had been very badly terminated at some point and had wire exposed.
Re-terminated and IP address changes made and camera worked again.

Next was the supply and fit of a new USB port and cable as original unit had become very temperamental.

Lastly the customer wanted the machine adding to their factory network in order to send drawings direct to the saw so cables were ran, network settings made and short cut from the office created.

14/10/2026

14/10/2026

Oxfordshire today to investigate roof camera problems, camera refusing to take images.

After conducting electrical tests, trying a new Silex box and cables we discovered the camera power supply is not supplying any voltage despite the transformer emitting 9volts.

New power supply required and roof camera setup to be carried out shortly .

13/10/2026

Visited North Wales today to investigate sizing errors when cutting mitres on a GMM Extra 400

The blade measure device was found to be providing incorrect information so calibration was carried out, also the slab probe was exaggerating material thickness by 1.5mm so recalibrated.

The W axis was found to be out of alignment along with machine offset quote problems so all were adjusted before test cuts to prove machine was now accurate once again.

12/10/2026

Derbyshire today resolving network credentials issues at a customers site, problem was found to be a compatibility error between windows 10 & 11 used in the office and windows seven embedded on the saws.

Some software downloads and configuration got everything talking and allowing drawings to be sent to the two GMM saws.