RyFab

Directions

RyFab Fabrication of custom exhausts & intercoolers. Chassis repairs to imports & performance cars. Based in Lisburn.
(1)

21/10/2026

Omega rear arches installed ✅️

A few repairs carried out on what is actually a cracking Omega Elite shell - it needed some work giving the age of the c...
21/10/2026

A few repairs carried out on what is actually a cracking Omega Elite shell - it needed some work giving the age of the car obviously but 90% of the car is mint 👌

The outer arches had a few rust spots & bubbles coming through, while inside the door frame and the front & rear of the sills were the worst areas on the car.

- Repaired the inner arches and installed new outer panels.
- Cut the rot out of the sills, cleaned & primed these areas and welded in new sections
- Removed a lot of studs from the engine bay for a clean, flush look
- Fixed and tidied a few small areas around the rear spring mount, jacking points and bulkhead etc.

Now just to fill the arches & sills with cavity wax and its ready to go home ✅️

2020 Tiguan 1.5 Turbo stainless exhaust finished up today ✅️V-band fl**ge added to the downpipe, secondary cat removed a...
13/10/2026

2020 Tiguan 1.5 Turbo stainless exhaust finished up today ✅️

V-band fl**ge added to the downpipe, secondary cat removed and dummy silencer fitted to the 2.5" system with dual 3" bevelled twin-tips.

Bit of repair work finished up on the Widetrack Impreza STi ✅️It came to me a couple of years ago needing the work and I...
07/10/2026

Bit of repair work finished up on the Widetrack Impreza STi ✅️

It came to me a couple of years ago needing the work and I didn't want to entertain it for my own sanity, so it was parked up until the owner wore me down enough to take it on 😂

- Inner strengthening panels cleaned back, treated and primed.
- New outer sills from Classiccarparts.ie fitted.
- Inner sills repaired in a few spots.

Inner arches were obviously in a bad way from years of daily use through the winter, especially around the fuel filler neck.

- New inner arches made
- Fuel filler neck area repaired
- New fuel filler pipe fitted
- Outer arches from classiccarparts.ie installed
- Back panel repaired & new bumper support bar fitted

Everything was then completely filled with cavity wax internally and I stonechipped the inner arches to give it some protection inside and out.

Now it'll never be a brand new Impreza again, but it did put a bit of driving back into the car for the owner as he has had it a very long time. Hopefully it doesn't see the winter roads anymore 👀

A few repairs carried out on this awesome midnight purple S15 😍The outer arches were starting to bubble and with the pai...
18/09/2026

A few repairs carried out on this awesome midnight purple S15 😍

The outer arches were starting to bubble and with the paint removed you could see it was spreading around the lip & where it had been rolled up for clearance on the wider wheels.

Removed the outer panel, cut away the inside lip & repaired it back to oem. Made new outer arches and spot welded them to the outer edge of the inner arch. I could then trim the lip back to about 5mm, almost the same diameter as if it was rolled to still have good clearance, so keeping the strength in the arch lip but without trapping any road dirt.

Repaired a small section on the door skin & two small chassis leg/sill repairs. Filled the arches with epoxy primer & then cavity wax so the owner can return to enjoying it as a daily.

Another E46 M3 but same story again, both inner arches full of fibreglass and sealer hiding some pretty bad rot & a bump...
09/09/2026

Another E46 M3 but same story again, both inner arches full of fibreglass and sealer hiding some pretty bad rot & a bump on the rear corner. 🙈

Only one way to sort it, cut away all the crap beyond the rust and start again. New inner arches made up of steel this time, primed and then fitted with new outer panels, and a few small repairs carried out in other areas.

All inner skins & welds painted after, then cavity waxed to protect them rusting from the inside out in years to come.

Ep3 with some nasty repairs finished up this week ✅️Lower quarter panels sections replaced.Inner arch lips repaired & ne...
13/08/2026

Ep3 with some nasty repairs finished up this week ✅️

Lower quarter panels sections replaced.
Inner arch lips repaired & new outer arch panels fitted.
Also replaced the lower inner arch sections which were made up of a few bits stuck together.

Primed, undersealed & cavity waxed. Tidied up & off for paint 👍

This isn't something you'll see every day - 1989 Mitsubishi Galant VR4 sitting on BC coilovers & Rays TE37's 🔰Always coo...
05/08/2026

This isn't something you'll see every day - 1989 Mitsubishi Galant VR4 sitting on BC coilovers & Rays TE37's 🔰

Always cool to have something different through the door, and this one is right up there with the Familia Sedan I done recently for rarity.

Finished up with a 3" turbo back exhaust, as its now away off to get mapped on a Link ECU. The customer wanted a 3" sharp twin-tip, no j*p can on this one for a change. Fairly changed the sound of the car as I couldn't even hear it pulling up, it made a nice note leaving though 👌

Finished up the 2jz turbo kit 2 years ago, before Bradley Motorworks sent it to over 600hp 💥
01/08/2026

Finished up the 2jz turbo kit 2 years ago, before Bradley Motorworks sent it to over 600hp 💥

Few repairs finished up on a customers' Bora yesterday. These arent a car I'd usually want to take on but it brought a b...
01/08/2026

Few repairs finished up on a customers' Bora yesterday.

These arent a car I'd usually want to take on but it brought a bit of life back into it and let him push on with building it back up to a good car again.

- Inner arches repaired & new outer arches installed.
- Inner sill & floorpan repairs carried out as they had been stoved up in.
- The inner panel cut & built back up to keep everything straight again.
- Outer sills primed & replaced.

Cavity wax pumped into the arches & sills after to protect the new panels.

Address

Lisburn

Website

Alerts

Be the first to know and let us send you an email when RyFab posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category