Workplace Safety Management Ltd

Workplace Safety Management Ltd Dust & fume extraction supply and install
Plymovent industrial products Midland distributer

If your extraction system isn’t capturing fumes at the source, your team is still breathing them in.Stationary filter un...
12/06/2026

If your extraction system isn’t capturing fumes at the source, your team is still breathing them in.

Stationary filter units are built for one job: consistent, reliable removal of harmful welding fumes and airborne contaminants, without disrupting your workflow.

The MonoGo and DualGo range delivers:

High-efficiency filtration for cleaner air
Fixed-position extraction for targeted control
Scalable options for single or dual workstations
Reduced exposure to hazardous particles

The risk isn’t always visible, but the damage builds over time.

If your current setup isn’t tested, maintained, or properly specified, it’s not doing its job.

Clean air isn’t a luxury in your workshop. It’s a requirement.
Get your system: https://workplacesm.com/plymovent-stationary-filter-units

10/06/2026

Off-the-shelf AC units are easy to buy and expensive to regret.

For commercial and industrial premises, the system needs to be specified for the building, the floor area, the heat load from equipment, the number of occupants, and the orientation of the space.

Get it wrong, and you're running an oversized system at unnecessary cost, or an undersized system that can't keep up on the days it matters most.

Workplace Safety Management provides full commercial air conditioning solutions across the Midlands.

Built right from the start. Maintained to stay that way.

Talk to our team → https://workplacesm.com/workplace-cooling

08/06/2026

Traditional air conditioning is expensive to install, expensive to run, and fixed in place.

For factories, warehouses, mezzanine floors, and large open-plan spaces, where your team moves, and the heat follows, a mobile evaporative cooler is a smarter starting point.

Portable. Energy-efficient. Immediately deployable.

WSM's mobile evaporative coolers deliver a constant flow of fresh, cooled air without the running costs of conventional AC, and because they're mobile, you position them where the heat actually is.

✔ Factories and manufacturing floors
✔ Warehouses and distribution centres
✔ Mezzanine and upper-level workspaces
✔ Event venues, marquees, and temporary spaces

Request yours before summer hits → https://workplacesm.com/workplace-cooling

Most compliance gaps aren't discovered by the HSE first; they're found by sites that audit themselves proactively.We've ...
03/06/2026

Most compliance gaps aren't discovered by the HSE first; they're found by sites that audit themselves proactively.

We've put together a quick 6-point self-check based on the most common findings from our LEV inspections across UK industrial sites.

Swipe through and be honest. If you can't tick all 6, it's worth speaking to us before someone else makes the same discovery.

Schedule a compliance review → https://workplacesm.com/

💬 Drop your score in the comments. How many did you confirm?

Most industrial businesses deal with a tangle of contractors when it comes to air quality:One company for equipment supp...
01/06/2026

Most industrial businesses deal with a tangle of contractors when it comes to air quality:

One company for equipment supply.
Another for installation.
A third for LEV testing.
Someone else for ongoing servicing.

Every handoff is a gap where accountability gets lost.

Workplace Safety Management handles all of it; from initial consultation and system design through to P601-accredited testing and annual service contracts.

One team. Full accountability. No gaps.

Find out what a complete solution looks like for your site → https://workplacesm.com/contact-us.

COSHH regulations have teeth. An HSE inspection that finds inadequate dust and fume controls can result in improvement n...
29/05/2026

COSHH regulations have teeth. An HSE inspection that finds inadequate dust and fume controls can result in improvement notices, prohibition orders, and significant fines.

But most compliance failures aren't deliberate; they're the result of gaps in knowledge or process.

Swipe to see the five most common mistakes we find when we audit industrial workplaces, and what to do about each one.

Need a COSHH compliance review? → https://workplacesm.com/contact-us

27/05/2026

The airflow gauge reads normal. The fan is running. The ducting looks fine from the outside.

But inside the system? Accumulated debris is partially blocking the duct. Suction velocity at the hood has dropped 40% below the design spec. Airborne contaminants are no longer being captured; they're drifting across the production floor.

This is what partial system failure looks like. And it won't trigger an alarm.

It takes a trained engineer with calibrated instruments, not a visual check, to know your system is actually working.

WSM provides P601-accredited LEV testing that measures real performance against COSHH design standards.

Book your LEV test → https://workplacesm.com/services/service-contracts-lev-p601-accredited-testing

Silica dust. Hardwood dust. Chromium fumes. Some of the most hazardous substances in UK workplaces are completely invisi...
25/05/2026

Silica dust. Hardwood dust. Chromium fumes. Some of the most hazardous substances in UK workplaces are completely invisible to the naked eye.

Yet under COSHH regulations, employers have a legal duty to prevent, not just reduce, exposure to airborne contaminants where reasonably practicable.

A properly designed and maintained extraction system isn't a nice-to-have. It's your primary line of defence.

Workplace Safety Management designs dust and fume extraction systems built around your specific processes and materials, not off-the-shelf guesswork.

Protect your team → https://workplacesm.com/contact-us

14/05/2026

Keeping Industrial Air Safe, One Check at a Time

Follow a day in the life of our certified engineers as they inspect, service, and report on LEV systems; protecting staff, ensuring compliance, and preventing downtime.

Book your maintenance today → https://workplacesm.com

Address

Unit 1 Garden Court, Gee Rd
Shepshed
LE674NB

Opening Hours

Monday 8am - 6pm
Tuesday 8am - 6pm
Wednesday 8am - 6pm
Thursday 8am - 6pm
Friday 8am - 6pm

Telephone

0116 2742336

Website

Alerts

Be the first to know and let us send you an email when Workplace Safety Management Ltd posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Workplace Safety Management Ltd:

Shortcuts

Share

Category