M S Marine Engineering Services

M S Marine Engineering Services Contact information, map and directions, contact form, opening hours, services, ratings, photos, videos and announcements from M S Marine Engineering Services, Plymouth.

The launch of a contessa 32 'retriever' after extensive overhaul, but she looks like new. Glad she's back in the water, ...
07/07/2022

The launch of a contessa 32 'retriever' after extensive overhaul, but she looks like new. Glad she's back in the water, and all new systems working. Next step mast install, and wire up.

A couple of months of hard work to get this beautiful oyster ready for going round the world, and onboard for its 1st pa...
16/06/2022

A couple of months of hard work to get this beautiful oyster ready for going round the world, and onboard for its 1st passage to Northern Spain. Happy travels Voyager II.

A prototype for crankcase breather modification to a volvo penta tamd41a
13/01/2022

A prototype for crankcase breather modification to a volvo penta tamd41a

An example of why you should service your heat exchanger on a regular basis
13/01/2022

An example of why you should service your heat exchanger on a regular basis

It's been 3 years in the making but the refit / restoration has finished
01/09/2021

It's been 3 years in the making but the refit / restoration has finished

27/10/2020

So you don't have a spark on your outboard say, before you start changing out coils, pick ups and modules. First you need to test all the components in this case inductive pickup was good(red), windings under the flywheel was good (yellow), coil switched feed from module was good (blue) and induction from coil lead no trace (green) gonna order up a coil

Project yamaha ME420STI, rejuvenation of this yamaha inboard and Sterndrive assembly, original problem was drive couplin...
25/07/2020

Project yamaha ME420STI, rejuvenation of this yamaha inboard and Sterndrive assembly, original problem was drive coupling had give up and the gimble housing had corroded away in places.

The reason you should drain any unused fuel from an outboard before standing it up for the winter
03/06/2020

The reason you should drain any unused fuel from an outboard before standing it up for the winter

Working late, last bit sanding and anti fouling where shes been sat in the pads.
17/07/2019

Working late, last bit sanding and anti fouling where shes been sat in the pads.

sometimes it is necessary to cut and join pre-made data cables, this one is a b and g ethernet cable which had to be fed...
10/01/2019

sometimes it is necessary to cut and join pre-made data cables, this one is a b and g ethernet cable which had to be fed through a helm station stainless tubing so there were no wires in the cockpit. the resistance of the cables are paramount due to low voltage data travelling over 10m, soldered, heat shrunk, shield reinstated and heat shrunk to be environmentally sealed for years to come. Its all about doing the job properly at ms marine engineering.

all 4 engine mounts replaced with engine in situe, using an ingenious method using hydraulics that I have perfected, a w...
30/11/2018

all 4 engine mounts replaced with engine in situe, using an ingenious method using hydraulics that I have perfected, a whole lot cheaper than having the engine lifted by a crane

There's something very satisfying about overhauling a set of motorcycle carbs! full strip, ultrasonic clean, repairs, se...
13/11/2018

There's something very satisfying about overhauling a set of motorcycle carbs! full strip, ultrasonic clean, repairs, service, and rebuild

Address

Plymouth
PL51

Telephone

447958297664

Website

Alerts

Be the first to know and let us send you an email when M S Marine Engineering Services posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share