Square type Cooling Tower operate on the induced draft counter flow principle operation. The fan creates air movement vertically pulled upwards on tower across the fills in opposition to the water flow. Hot circulating water enters the water inlet headers and sprays through non clogging PP spray nozzle. Water distribution is even. Well designed PVC Drift Eliminators are fitted to reduce Drift Loss
es. Square Fiber Glass Cooling Towers are provided with Inspection door for easy access for inspection and maintenance. Square tower can be installed in multi cell also. Cooling Tower Capacity:
We offer square type FRP Cooling Towers of Capacity ranging from 5TR to 600 TR in Single cell and as per requirement of client in multi-cells. We also Repairs / Revamps any types of existing Cooling Towers considering the total system approach. Benefit:
Compact design, corrosion resistant and lightweight
Durable service Life
Maintenance free
Higher efficiency
Minimum drift loss of water
No contamination, due to dust or foreign particles
Piping cost negligible and suitable for small unit
Assembly:
FRP CASING
Cooling Tower Casing is made of selected grade materials of tough Fiber Glass Reinforced Polyster and resins etc. An additional embossing is provided for extra strength of large Cooling Towers. HEADER PIPES:
The header pipe designed for proper distribution of water over the FILLS so that proper contact time for air to water is achieved. The header pipe is manufactured in G.I., P.P. with FRP moulded construction which makes it NON CORROSIVE TYPE & Long Lasting. WATER DISTRIBUTION NOZZLE
We are offering low pressure drop, non-clogging, ABS make solid cone type nozzle for distributing the water on the fill pack area. Each nozzle is designed to operate on a water fluctuating load as good as 20%. Each nozzle can cater the service area of 1.2m x 1.2m at an inlet pressure of 0.3 kg. Drift Eliminator:
CCS Drift eliminators, to reduce carry over losses through of moistures drop in the air stream. The individual drift eliminators of s-shaped corrugated sheets are bonded with subsequent layer to creat the structure. PVC Honeycomb Fills:
PVC Honeycomb type fills having extended contact area. Splits incoming air and water into several streams spread evenly across the water cross section increasing heat transfer rate easy to replace. Material of Construction
Shell FRP using Neo Penta Glycol Gelcoat and Isopthetic Resin
Structural M.S. hot dip Galvanized
Ladder M.S. Hot dip Galvanized
Spray System Galvanized Iron / PP FRP
Water Distribution Non Clogging PP Nozzle
Hardware HDG / SS -304
Fills PVC- honeycomb type made by Vacuum Forming Process
Basin FRP with NPG Gelcoat & Isopthetic Resin
Fill Support M.S. Hot Dip Galvanized
Ladder M.S. Hot Dip Galvanized,
Fan Blades Dynamically balanced Cast Aluminium Alloy / ABS Engg. Plastic / FRP Fan
Type of Drive Co-Axial Flow Direct Driven. Fan Motor Type TE-IP 55 With EN -8/9 Shaft.
