GL Engineering Support Sdn Bhd

19/10/2026

When production was running well yesterday but today's output is different, the first question should not always be:

“What's wrong?”

A better starting point can be:

“What changed?”

Material, setup, tooling, feeding condition, process or production sequence — not every change is the cause, but knowing what changed gives you a meaningful place to start.

⚙️ Sometimes, better troubleshooting starts with understanding the difference between a good run and a bad one.

17/10/2026

17/10/2026

Looking for a reconditioned 160-ton power press?

Our SEYI SN1-160, a 160-ton single-crank power press, is ready for testing.

If your factory is looking to add another press or replace an existing machine, come and inspect the machine and test it for yourself.

📩 Contact us to arrange a machine test.

13/10/2026

ALONG THE WAY | A Look at Our Work

A little glimpse of what we do on the factory floor.

Every job is different, and sometimes it’s all about getting on-site, checking things out, and figuring out what needs attention.

Just another day of engineering support.

06/10/2026

"THE FIRST BAD PART MAY NOT BE WHERE THE PROBLEM STARTED.

When the first bad part appears, it is easy to look at the machine and ask:

“What went wrong?”

But the visible problem may only be the final result of something that changed earlier — during setup, feeding, tooling, material, or the process itself.

The first bad part tells you when you noticed the problem.

It doesn't always tell you when the problem began.

⚙️ Sometimes, better troubleshooting starts by looking backwards — not just at the point where the problem appears.

28/09/2026

Got a 160-ton press requirement?

We currently have a 160-ton single-crank power press, reconditioned Chin Fong OCP-160, ready for testing.

Whether you're looking for an additional press, replacing an existing machine, or comparing your options, you’re welcome to come and see the machine for yourself.

Test the machine before you decide.

📩 Contact us to arrange a machine test.

23/09/2026

YOUR MACHINE IS RUNNING. IS IT REALLY PRODUCING?

A machine can be running for hours without making the most of its available production time.

Adjustments, waiting, setup, minor stoppages, and running below the intended pace can all add up.

When you review machine performance, don’t only look at running hours.

Look at what those hours actually produced.

⚙️ Sometimes, improving output isn’t about running the machine longer — it’s about making better use of the time it is already running.

16/09/2026

🇲🇾 Different backgrounds. Different stories. One Malaysia.

Today, we celebrate the people, spirit and diversity that make our country what it is — and the shared journey that continues to move us forward.

Selamat Hari Malaysia! 🇲🇾

15/09/2026

A good machine can still be a bad investment.

Not because the machine is bad — but because it may not solve the problem you actually have.

When you're evaluating a machine, ask:

What problem are we solving?
What do we expect to improve?
What should be different after the investment?

A machine can have great specifications and still be the wrong fit.

The right machine is the one that solves the right problem.

12/09/2026

NEW OR REFURBISHED?

In Malaysia’s manufacturing industry,
when factories look to upgrade equipment or increase capacity,
both new and refurbished machines can be part of the consideration.

New machines can bring newer technology, performance and configurations,
while refurbished machines may offer the familiarity of proven equipment and established processes.

But equipment investment
is never simply about “new” or “old.”

What matters is what it needs to achieve for the factory.

So—

New or refurbished?

Perhaps, the answer was never in the machine itself.