Black Betty Plasma Cutting LLC

06/09/2026

Last night I got the shock mounts for my C10 welded up, tonight I will install them quick in time for the car show Wednesday evening at Canteen Bar & Grill

06/06/2026

Finally getting ready to install some front shocks on my C10.

05/29/2026

Little photo dump from a recent job that was finished up. I was asked to take a set of CPP brand control arms for a C10 and shorten them 1", reason being this suspension is actually under a bagged Apache truck. Some measurements of the arms were taken and rough drawn in solidworks to design some jigs to align the new ball joint positions.

05/25/2026

05/20/2026

https://www.etsy.com/shop/BlackBettyPlasma?ref=anchored_listing&fbclid=IwVERFWAR53YVleHRuA2FlbQIxMABzcnRjBmFwcF9pZAwzNTA2ODU1MzE3MjgAAR7QLUdTINHIsbTZpxjp3Jl0CzpoG2eIHxAWlvz0AawQT6gwFm9z8yUuHn-luw_aem_9_zST-c9V_pa44vEu85BCw

Shop Metal Fabrication Located in Randall Minnesota by BlackBettyPlasma located in Randall, Minnesota.

05/08/2026

Today's post is about the C10, unfortunately the 6.0 grenaded christmas eve so now it's almost ready to go again with another 6.0 that is cammed, newer heads, and finally finshed the T56 hybrid trans. Once done we will be out at some shows in central MN and putting some miles on it.

05/08/2026

Been a few months since I was last on this page so here are some photos of projects completed since the last post. I have a bunch of projects lined up and few more I'm already started on so I hope to be posting more often again.

02/12/2026

4 link and watts link I just finished up for a 1950s ford panel heading off tomorrow.

01/15/2026

This winter we been working on a 1953 Chevy 3600 which we stripped down the stock frame, installed the bolt in mustang 2 coilover front suspension from Speedway motor, custom designed trans crossmember to hold the 4l60e to the 5.3 engine, and doing custom rear coilover 4 link setup. Next yp we will get the donor cab mocked up on the frame and get it ready for some sheetmetal repair.