Mitchell Fabrication

Directions Website

Mitchell Fabrication Santa Rosa Beach metal fabrication shop building custom off-road, race, and high-performance vehicles.

Roll cages, tubular chassis, exhaust, suspension, and one-off components fabricated in-house for clients across Northwest Florida.

Custom rollcage and aluminum rear panel for package tray/seat delete. 1966 Mustang
10/08/2026

Custom rollcage and aluminum rear panel for package tray/seat delete. 1966 Mustang

07/02/2026

Custom made 3" oval X-pipe to 3" round full exhaust for 1969 Camaro

04/07/2026

Just what this H1 needed. 40" BFGoodrich Tires, Black Rhino Wheels with Baja Designs LP6's, and cleaning up all the clearance lights with fresh LED's.
New front brush guard and rear tire carrier to finish this one out

Some what of a rendering of what and how the paint scheme will be layed down on the widebody Jeepster
03/20/2026

Some what of a rendering of what and how the paint scheme will be layed down on the widebody Jeepster

Ferrari F430 custom rollcage for a Client in Destin, Florida. Cut the pre-existing cage out, modified the main hoop, and...
03/09/2026

Ferrari F430 custom rollcage for a Client in Destin, Florida. Cut the pre-existing cage out, modified the main hoop, and door bars with tube connectors which made it "modular" Then powdercoated the entire cage to match up with the racing stripes

03/01/2026

It's not perfect, but perfection is boring. Lot's of time in this tailgate. Changed hinges, which caused the tailgate to swing out more (which is what I wanted) if you know about the Jeepster tailgates, which ride and rub paint on the factory Jeeps because lack of clearance and very sloppy hinges. So swinging out further eliminated it getting chipped when opening or closing. Then had to create a tailgate support/limiter (didn't want to use a strap or cable, because it would just bind up inside the gap between the tailgate and the quarters, (there's no room) so I created this swing style tailgate limiter, that just folds back up. With that, had to make bearings, basically everything you see in the pics above. Then once again spun up some aluminum k***s to match everything else that was fabricated

Address

Santa Rosa Beach
Santa Rosa Beach, FL
32459

Opening Hours

Monday 9am - 5pm
Tuesday 9am - 5pm
Wednesday 9am - 5pm
Thursday 9am - 5pm
Friday 9am - 5pm

Website

Alerts

Be the first to know and let us send you an email when Mitchell Fabrication posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category