Tonka Toy Fabworks

10/18/2026

Its been quite but I have been busy I had to pull a very tight fitting 5.3 out of a colorado so I could drop one in that didnt make some bad noises all new gaskets and oil pump now I am a waiting on parts to finish that up. While I was waiting I got some more of my rusty floor repaired and since my ummm "gas guy" let me run out of wire I am waiting on that now also.

09/22/2026

It might not all be perfect but it is all way better than I use to be.

09/20/2026

09/20/2026

This old drag car got a little stainless exhaust action waiting on parts to finish but pretty good progress so far.

09/17/2026

This weeks project is probably the coolest thing I have had on my lift. So far I got a crossmember that someone else had done some work on cut out and repaired with some DOM tubing that also gave a little more clearance for the driveshaft. Next up is full stainless exhaust to to send that 440 big block sound to the rear of the car.

09/13/2026

No more rusty steps on the bed now.

09/13/2026

Finally got a productive saturday in the garage today I got just about all of the step build on the passenger side of the bed. I think the hardest part was trying to match it to the driver side it turned out pretty close.

09/03/2026

From rust to paper to fresh metal with a little more work it will be fixed.

08/31/2026