Modz Machining

10/05/2026

Some custom steel support and straightening braces for the underside of a kitchen island counter top this week. Hope everyone has a great week ahead of them!

08/27/2026

08/27/2026

Little shaft work this week for a rake. Hope everyone enjoys the weekend ahead!

07/15/2026

Customer said this thing is all over the place on target. Found a few things we didn’t like and would do differently. Going out for testing this weekend. 7mm PRC previous/original barrel vs the replacement we fit up. Be careful out there. Cant wait to see the feed back. Thank you to our customers for trusting us in getting things dialed back in

07/15/2026

Customer said this thing is all over the place on target. Found a few things we didn’t like and would do differently. Going out for testing this weekend. 7mm PRC previous/original barrel vs the replacement we fit up. Be careful out there. Cant wait to see the feed back. Thank you to our customers for trusting us in getting things dialed back in

06/16/2026

Some aluminum plugs fresh off the lath on their way to out customer. Thank you for the trust and business. Hope everyone has a great week ahead of them!

06/10/2026

Large 2 1/2 “ threaded cap. Never had to chase an internal thread until this project. Always made myself a check gauge or had the part to fit it to. Thankful to continue learning along the way. Little nerve racking as the part was complete and finished and definitely didn’t want to scrap it. Got it handled and painted up for the customer. Thank you to our family, customers, and friends for the support On to the next one.

06/10/2026

Large 2 1/2 “ threaded cap. Never had to chase an internal thread until this project. Little nerve racking as the part was complete and finished and definitely didn’t want to scrap it. Got it handled and painted up for the customer. Thank you to our family, customers, and friends for the support On to the next one.

06/08/2026

Fit and finish on the mini excavator thumb mount bushings 😎 Had some fun designing the upper bushings to not only take up the sloppy fit in the holes but also position the top of the cylinder in the middle of the boom where it belongs. Thank you to Blue Collar Biz and Leister Service out of Kewaskum Wi for the opportunity!