Bowman Fabrication

Bowman Fabrication This is currently a side business that I hope to grow into a way to make my living. I am an amature auto cross and rally cross racer.

Old man groaners shift knobs is a side business that I have created to help fun my passion for racing.

05/26/2026

I just finished swapping out mufflers on this 85 blazer. The old system was so quiet you couldn’t even hear it. The owner wanted a nice rumble at idle and to have a good exhaust note when he gets on it. We decided to go with some magnaflow mufflers and very happy with the result.

01/12/2026

Project lake find update! Crank but no start back to running. Heat cycled the motor, ran the track a bit and it’s almost ready for a test run on the snow! Lesson from this sled is that if you have low compression check your reed valves before assuming you need a full top end rebuild.

12/30/2025

It’s alive!!! Hopefully it stays that way. I still have a lot of clean up to do on this sled to get the silt and hay debris out of everywhere. I broke a ni**le on the coolant expansion tank so I can’t run it much until my new one arrives. Pretty stoked about this one. Hopefully this is a testament of how well sleds are built.

If you find pig in a poke kind of deal send them my way. Maybe it will be my next project.

Cutting off the old spring hangers on this xj is no joke. It has required a much more delicate approach than I first ant...
12/15/2025

Cutting off the old spring hangers on this xj is no joke. It has required a much more delicate approach than I first anticipated. Today’s progress involved getting the last of the hangers off and cleaned up. Then the wonderful process of mock up began. At this point the new adjustable rear hangers are fully welded and painted. The front hangers are only tack welded in place. Tomorrow I will continue to fine tune the shackle angle by moving the front hangers if needed. As it sits currently it’s very close to where it wants to be. The .desert.fox is going to ride like a Cadillac with the new shackle angle.

I haven’t had nearly as much time this weekend as I was hoping for. Made some quick progress on .desert.fox today. Rear ...
12/08/2025

I haven’t had nearly as much time this weekend as I was hoping for. Made some quick progress on .desert.fox today. Rear bumper, rear axle, leaf springs, and shackles are removed. The right rear shackle hanger is removed and the new rough stuff adjustable mount is mocked up. Most of the front leaf hanger is also removed as well. The front is putting up much more of a fight than the rear, but I’ll win this fight. I always do.

10/24/2025

update! Progress is slow but steady. We are finally to the stage of setting out gaps and doing the metal work! Lots to fine tune as always but once we get plugging away at it, the changes should happen pretty quick. If you have any questions comments or concerns please comment below and I will do my best to answer them.

10/24/2025

In class yesterday we played with some panel bond. We performed destructive testing on test panels. Some of them had only panel bond, some weld bonding, and some rivet bonding. Amazingly all of our panels held at least 4,000 lbs of pulling pressure before they failed and usually the steel of the panel tore rather than the bonding adhesive.

Address

3418 S Ovation Drive
West Valley City, UT
84128

Telephone

(801) 592-0633

Website

Alerts

Be the first to know and let us send you an email when Bowman Fabrication posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Bowman Fabrication:

Shortcuts

Share